Before buying replacement print cartridges, verify the
correct part number.
(for the ViewPlus PIA use VPT9003-00, sold in packages of
3)
To replace or insert cartridge:
- Load
paper
- Be
sure that the PIA is attached to the ViewPlus Pro.
- Turn
on the embosser.
- Put
your finger on the grooved part of the door on the top of the PIA, and
slide the door open.
Illustration of door open and finger on grooves
- While
the door is open, the ink cartridges should be positioned for easy access.
- Remove
the ink cartridges from the packaging and carefully remove the plastic
tape.
Caution! Do
not touch the print cartridge ink nozzles or copper contacts. Touching these parts will result in clogs,
ink failure, and bad electrical connections.
Do not remove the copper strips.
They are required electrical contacts. Like all ink cartridges these ink
cartridges are susceptible to drying out if exposed to the air or not used for
extended periods.
Illustration of removing plastic tape
- Hold
the print cartridge so that the copper strip is on the top and the plastic
tab is on the bottom facing away from the printer. Then insert the print cartridge top
first into the cradle as shown. Do
the same procedure for the second print cartridge.
Illustration of cartridge installation
- You
will see the message (Replace Cart. 1(or2) ? ) and hear the message, "Select to
confirm Cartridge 1 (or 2) replacement"
- Confirm
by pressing the Select button. If
you have replaced both cartridges, you must repeat steps 8 and 9.
- Follow
the instructions in the manual for the Ink-Emboss Alignment.
| 
