FCC
Compliance Statement (USA)
This equipment has been tested and found to comply
with the limits for a Class A digital device, pursuant to Part 15 of the FCC
Rules. Operation is subject to the following two conditions: (1) this
device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired
operation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of
the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment
and receiver.
- Connect the equipment to an outlet on a circuit
different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV
technician for help.
FCC Warning: Changes
or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
Note the following:
- The use of a non-shielded interface cable with
the referenced device is prohibited.
- The length of the parallel interface cable must
be 3 meters (10 feet) or less.
- The length of the serial interface cable must be
15 meters (50 feet) or less.
- The length of the power cord must be 3 meters
(10 feet) or less.
Compliance Statement (Canada)
This
digital apparatus is in conformity with standard NMB-003 of Canada.
Cet appareil num?rique est conforme à la
norme NMB-003 du Canada.
Compliance Statement (Germany)
Bescheinigung des Herstellers/Importeurs:
Hiermit wird bescheinigt, dass der Drucker der
Maschinenlärminformationsverordnung 3. GSGV, 18.01.1991 entspricht: Der höchste
Schalldruckpegel beträgt 70 dB(A) oder weniger gemäß EN27779-1991.
Compliance Statement (Europe)
Warning: This
product meets the interference requirements of EN55022. In a domestic
environment, this product may cause radio interference in which case, the user
may be required to take adequate measures.
Compliance Statement (Korea)
This apparatus complies with
CISPR22 requirements.
International Compliance
EN55022:1994 Emissions
series
EN55024:1998 Immunity
characteristics
EN61000-3-2:1995 Power line
harmonics
EN61000-3-3:1995 Power line
flicker
EN61000-4-2:1995 Electrostatic
discharge
EN61000-4-3:1995 Radiated
susceptibility
EN61000-4-4:1995 Electrical
fast transient/burst
EN61000-4-5:1995 Surge
EN61000-4-6:1996 Conducted
immunity
EN61000-4-11:1994 Input voltage interruptions/DIPS
