FCC COMPLIANCE STATEMENT (USA)
This
equipment has been tested and found to comply with the limits for a
Class A digital device, pursuant to Part 15 of the FCC Rules. Operation
is subject to the following two conditions: (1) this device may not
cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired
operation. If this equipment does cause harmful interference to radio
or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.Increase the separation between the equipment and receiver.
- Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC
Warning: Changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate
the equipment.
Note the following:
-
The length of the parallel interface cable must be 3 meters (10 feet) or less.
-
The use of a non-shielded interface cable with the referenced device is prohibited.
-
The length of the power cord must be 3 meters (10 feet) or less.
-
The length of the serial interface cable must be 15 meters (50 feet) or less.
COMPLIANCE STATEMENT (CANADA)
This digital apparatus is in conformity with standard NMB-003 of Canada.
Cet appareil num?rique est conforme à la norme NMB-003 du Canada.
COMPLIANCE STATEMENT (GERMANY)
Bescheinigung des Herstellers/Importeurs:
Hiermit
wird bescheinigt, dass der Drucker der
Maschinenlärminformationsverordnung 3. GSGV, 18.01.1991 entspricht: Der
höchste Schalldruckpegel beträgt 70 dB(A) oder weniger gemäß
EN27779-1991.
COMPLIANCE STATEMENT (EUROPE)
Warning:
This product meets the interference requirements of EN55022. In a
domestic environment, this product may cause radio interference in
which case, the user may be required to take adequate measures.
COMPLIANCE STATEMENT (KOREA)
This apparatus complies with CISPR22 requirement
|
|
EN55022:1994 - Emissions series
EN55024:1998 - Immunity characteristics
EN61000-3-2:1995 - Power line harmonics
EN61000-3-3:1995 - Power line flicker
EN61000-4-2:1995 - Electrostatic discharge
EN61000-4-3:1995 - Radiated susceptibility
EN61000-4-4:1995 - Electrical fast transient/burst
EN61000-4-5:1995 - Surge
EN61000-4-6:1996 - Conducted immunity
EN61000-4-11:1994 - Input voltage interruptions/DIPS |
