Before buying replacement print cartridges, verify the correct part number. For the ViewPlus Emprint, use VPT9014-00 (Black) and VPT9015-00 (Tri-color).
HP 56 (Black) and HP 57 (Tri-color) are also recommended.
Your Emprint will notify you when the ink level is low. At this time, make sure that you have
replacement cartridges available. Either
replace the cartridges or wait until your ink stops printing. The ink level can also be checked using the Service tab in the Emprint printer properties.
To replace or insert cartridge:
- Load paper.
- Turn on the embosser.
- Open lid of the Emprint.
Illustration of the Emprint
with the lid open showing cartridges on the right.
Illustration of the Emprint
with the holder open.
- The ink cartridges should
be positioned for easy access. The
black ink cartridge holder is labeled 56 and can be found on the right
side. The tri-color ink cartridge
holder is labeled 57 and is located to the left of the black ink cartridge
holder.
- Remove the ink cartridges
from the packaging and carefully remove the plastic tape.
Caution! Do not touch the print cartridge ink nozzles or
copper contacts. Touching these parts will result in clogs, ink failure and
bad electrical connections. Do not remove the copper strips. They
are required electrical contacts. Like all ink cartridges, these ink cartridges
are susceptible to drying out if exposed to the air or not used for extended
periods.
Illustration of removing plastic tape.
- Hold the print cartridge so
that the copper strip is on the top and the plastic tab is on the bottom
facing away from the printer. Then insert the cartridge top
first into the cradle as shown. If you need to replace both
cartridges, do the same procedure for the second print cartridge.
Illustration of cartridge installation.
| 
