Login | Register

 ViewPlus Emprint SpotDot Manual

Table of Contents
I. Introduction
- Preface
- FCC Compliance Statement
- Safety Instructions
II. General Information
- Specifications
- Software Driver
III. Installation
- Unpacking
- Rear Paper Path Extension and Lid
- Insert Output Tray
- Cable Attachment
- Software Installation
- Ink Cartridges
- Alignment
IV. Operator Panel
- Functions
- Displays
- Tones
V. Paper Handling
- Paper Loading
- Paper Jams
VI. Braille
- Fonts
- ViewPlus Tiger Software Suite
VII. Tiger Printer Driver
- Introduction
- Tiger Tab in Printer Properties
- Legacy
- Service Tab
VIII. Printing First Documents
- Printing
- Printer Properties
IX. Accessories and Support Packages
- Accessories
- Other Software Packages
- Training and Support Packages
X. Maintenance and Warranty
- Maintenance
- Warranty
- Extended Warranty and Maintenance Plan

 Chapter V: Paper HandlingBegin Main Content
 
 
A.   Paper Loading
The ViewPlus Emprint SpotDot takes stacks of single sheet print media. Insert the paper from the front into the input tray.


Shows the input tray in the front of the embossing printer
 
B.   Paper Jams
Paper jams can occur in the main body of the embossing printer or in the rear paper path extender. To check and clear paper jams please follow the steps below.
Note: Always pull the paper from the center of the visible side or with one hand on each edge of the paper so the pulling force is distributed. This way it is less likely that the sheet will be torn into pieces which might be harder to remove.
  • If the embossing printer is indicating a paper jam, turn the embossing printer off.
  • Open the housing lid and check for paper inside. If there is paper present, in most cases it can be removed from the area where the ink cartridges would move over the paper. (If the ink cartridges are stuck on jammed paper, move them manually over to the right side).
    • First try to free the paper from underneath the flat metal part towards the front of the embossing printer by pulling the paper towards the back of the embossing printer.
    • Then try to free the paper from underneath the small metal rollers towards the back of the embossing printer by pulling the paper towards the front of the embossing printer.
  • If you cannot remove the paper using the methods described in the previous steps or if the area underneath the lid is free of paper, check for paper within the rear paper path extender.
  • To remove the rear paper path extender press the buttons on the left and right sides of the accessory and pull it away from the embossing printer. Remove any paper jam inside the embossing printer.
  • To check the inside of the rear paper path extender, press the button on top of the accessory and lower the access door. Remove any paper jam from inside the rear paper path extender and close the door again.
  • Reinsert the rear paper path extender into the embossing printer until both sides snap into place.
  • Turn on the embossing printer, and then reprint the document.
 
Copyright © 2007 ViewPlus Technologies, Inc.
All ViewPlus products are Section 508 compliant.