ViewPlus IVEO Touchpad and Touchpad Portable Manual

Table of Contents
I. Introduction
	-	IVEO Touchpad Setup Instructions
	-	Preface
	-	Safety Instructions
II. Installation
	-	Installing the Touchpad Hardware
III. Calibration
	-	Introduction
	-	Creating Initial Setup Pattern for IVEO Touchpads
	-	Creating a Map for Calibrating the On-screen Image to the Printed Image
IV. Warranty Information
	-	Warranty

Chapter II: Installation


A.	Installing the Touchpad Hardware

	Remove your IVEO Touchpad or Touchpad Portable from the box. It is packaged in a plastic bag. Open the bag and remove the touchpad from the bag. Included with your touchpad is a USB cable in a smaller, resealable bag. Remove the cable from that bag. Plug the square end of the cable into the touchpad and the rectangular end of the cable into a USB port on your computer. The IVEO Touchpad and Touchpad Portable are oriented landscape. Place your touchpad on a level, flat surface like a desk, or on your lap. The side with the USB plug should be at the back of the touchpad, away from you.