ViewPlus Pro Gen II Embosser Manual

FCC COMPLIANCE STATEMENT (USA)

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.  Increase the separation between the equipment and receiver.
• Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

FCC Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

Note the following:

• The length of the parallel interface cable must be 3 meters (10 feet) or less.
• The use of a non-shielded interface cable with the referenced device is prohibited.
• The length of the power cord must be 3 meters (10 feet) or less.
• The length of the serial interface cable must be 15 meters (50 feet) or less.

COMPLIANCE STATEMENT (CANADA)

This digital apparatus is in conformity with standard NMB-003 of Canada.

Cet appareil numérique est conforme à la norme NMB-003 du Canada.

COMPLIANCE STATEMENT (GERMANY)

Bescheinigung des Herstellers/Importeurs:

Hiermit wird bescheinigt, dass der Drucker der Maschinenlärminformationsverordnung 3. GSGV, 18.01.1991 entspricht: Der höchste Schalldruckpegel beträgt 70 dB(A) oder weniger gemäß EN27779-1991.

COMPLIANCE STATEMENT (EUROPE)

Warning: This product meets the interference requirements of EN55022. In a domestic environment, this product may cause radio interference in which case, the user may be required to take adequate measures.

COMPLIANCE STATEMENT (KOREA)

This apparatus complies with CISPR22 requirement

• Do not place printer on an unstable surface.
• Do not place printer near a radiator or heat source.
• Do not block or cover slots and openings in the printer's cabinet; do not inset objects through slots.
• Use only the type of power source indicated on printer's label.
• Connect all equipment to properly grounded electrical outlets.
• Do not use frayed or damaged power cord.
• The use of an extension cord with the printer is not recommended.
• Unplug printer before cleaning it; always clean it with a piece of damp cloth only.
• Do not spill liquid into printer.
• Except as specifically explained in the user's manual, do not attempt to service the printer by yourself.
• Detach the printer from power source and refer to qualified service personnel under the following conditions:
• If the power cord or plug is damaged
• If liquid has entered the printer.
• If printer has been dropped or the cabinet is damaged.
• If the printer does not operate properly or exhibits a distinct change in performance.

• Only adjust those controls that are covered by the operating instructions.