FCC Compliance Statement (
USA)
This equipment has been tested and found to comply with the limits for a
Class A digital device, pursuant to Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation. If this equipment
does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
- Reorient or relocate the
receiving antenna.
- Increase the separation
between the equipment and receiver.
- Connect the equipment to an
outlet on a circuit different from that to which the receiver is
connected.
- Consult the dealer or an
experienced radio/TV technician for help.
FCC Warning: Changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate the equipment.
Note the following:
- The use of a non-shielded
interface cable with the referenced device is prohibited.
- The length of the parallel
interface cable must be 3 meters (10 feet) or less.
- The length of the serial
interface cable must be 15 meters (50 feet) or less.
- The length of the power
cord must be 3 meters (10 feet) or less.
Compliance Statement (
Canada)
This digital apparatus is in conformity with standard NMB-003 of
Canada.
Cet appareil num?rique est conforme à la norme NMB-003 du Canada.
Compliance Statement (Germany)
Bescheinigung des Herstellers/Importeurs:
Hiermit wird bescheinigt, dass der Drucker der
Maschinenlärminformationsverordnung 3. GSGV, 18.01.1991 entspricht: Der höchste
Schalldruckpegel beträgt 70 dB(A) oder weniger gemä?? EN27779-1991.
Compliance Statement (Europe)
Warning: This product meets the interference requirements of EN55022. In a
domestic environment, this product may cause radio interference in which case,
the user may be required to take adequate measures.
Compliance Statement (
Korea)
This apparatus complies with CISPR22 requirements.
International Compliance
EN55022:1994
Emissions series
EN55024:1998
Immunity characteristics
EN61000-3-2:1995 Power line
harmonics
EN61000-3-3:1995 Power line
flicker
EN61000-4-2:1995 Electrostatic
discharge
EN61000-4-3:1995 Radiated
susceptibility
EN61000-4-4:1995 Electrical fast
transient/burst
EN61000-4-5:1995 Surge
EN61000-4-6:1996 Conducted
immunity
EN61000-4-11:1994 Input voltage
interruptions/DIPS