| |
|
A. |
Initial Setup of Touchpad |
|
|
The
IVEO Touchpad is oriented landscape. Place the Touchpad on a level, flat
surface like a desk, or on your lap. The side with the clamp should be on the
left and the USB plug should be at the back of the Touchpad, away from you.
Installation of all
necessary software for the IVEO Touchpad is done automatically when the IVEO
Viewer or Creator is installed. Install
and open either the IVEO Creator or Viewer to proceed with setup, calibration,
and use of the IVEO Touchpad.
The touchpad must be set up to work with the monitor on your computer, and then
the IVEO software must be calibrated so the screen image is properly positioned
relative to the touchpad. These steps are VERY IMPORTANT. The application will
not work properly with the touchpad until these two steps are finished.
- In the File menu Preferences item, be
sure that the Accessibility mode, fixed screen, and Windows dialogues are
selected.
- Be sure the IVEO Touchpad Initial Setup
pattern is in place. The touchpad is
shipped with the initial setup pattern clamped into place. If it has been removed or lost, consult
the IVEO Touchpad Manual for instructions on placing tactile images onto the
touchpad or embossing a new copy if the original initial setup pattern has
been lost.
- Use the
“Perform IVEO Touchpad Setup” item in the Touchpad menu to start the setup
process. Note that the process
times out ten seconds after each operation. If it times out, start over.
- After starting the setup process, press the single dot in
the lower left corner of the calibration page. After hearing a tone, keep holding down for about 3 seconds.
- Do the same
press and hold process on the double dot in the upper right-hand corner,
- Do the same
press and hold process on the triple dot in the upper left corner.
- A window
should now pop up to tell you that the setup is finished. Click ‘OK'.
Once the touchpad has been set up, it should
never need it again on that computer. |
| |
|
B. |
Calibration of IVEO Touchpad |
|
|
The final step is to calibrate the screen image to the touchpad. This calibration should also need to be done
only once.
- Replace the
initial setup pattern with the US map that was included with
the IVEO Touchpad. Depending on which software you have installed, consult the IVEO Creator Manual or the IVEO Viewer Manual if the original map has been lost and a new one needs
to be embossed. Open the clamp and
place the map in the upper left corner, then close the clamp to hold
it.
- Press CTRL-u
or go to the ‘Touchpad menu and select “Calibrate from Current Image”.
- The Viewer
will say "Touch top left corner of the image." Touch the top left
point of the embossed corner on the top left (Note, this embossed corner
is below the row of boxes). The Viewer will say "Press space to
confirm". If you touched the wrong
place, continue touching until you believe you have touched the correct
point and then press the space bar.
- You will then
be prompted to "Touch the bottom right corner of the image." Touch the bottom right point of the
embossed corner and when you have touched the correct place, confirm by
pressing the space bar.
Your
IVEO Touchpad and Viewer or Creator should now be calibrated.
|
| |
